Items where Division is "Faculty of Engineering > Department of Manufacturing Engineering" and Year is UNSPECIFIED

Up a level
Export as [feed] Atom [feed] RSS 1.0 [feed] RSS 2.0
Group by: Creators | Item Type | No Grouping
Jump to: C | F | G | K | O | P | S | T
Number of items: 11.

C

Candra, Susila and Batan, I Made Londen and Berata, Wajan and Pramono, Agus Sigit (2016) ANALISIS DAN EKSPERIMEN BLANK HOLDER GAP MINIMUM PADA PROSES RECTANGULAR CUP DEEP DRAWING. Teknoin, 22 (5). pp. 372-382. ISSN 0853-8697

F

FRANSISKA, DEWI (2016) Pemodelan Matematik untuk Menentukan Hubungan antara Parameter Proses dan Kekasaran Permukaan pada Proses Turning Baja Tahan Karat 316L. [Undergraduate thesis]

G

Gunawan, Mishael Eleosca (2016) Improvement Design Alat Bantu Menggendong Pasien Manula (Patient Lifter). [Undergraduate thesis]

K

KUNCORO, ROBBY GUNADI (2016) Finite Element Analysis pada Desain Engsel Pintu Box Berbahan AA 6063-T6 Extrusions dengan Menggunakan Software Cad/Cae. [Undergraduate thesis]

O

OSWAN, EVAN PRADANA (2016) Perancangan Tenda Jenis Sarnafil dengan Proses Pemasangan Lebih Cepat dan Meminimalkan Jumlah Operator untuk Pemasangan. [Undergraduate thesis]

P

PRECILLYA, FINNY (2016) Pengaruh Arus (I) dan Waktu (t) Electropolishing Terhadap Kualitas Permukaan Baja Tahan Karat A316L. [Undergraduate thesis]

S

SHINTA, DEWI (2016) Pengaruh Parameter Proses Milling Terhadap MRR dan Kekuasaan Permukaan Pada Pemotongan Material SUS316L. [Undergraduate thesis]

SUSANTO, HERMAN (2016) Perancangan Mesin Pelurus Kawat. [Undergraduate thesis]

Suteja, The Jaya (2016) The Influence of Depth of Cut, Feed Rate, and Step-over on Dimensional Accuracy in Subtractive Rapid Prototyping of Polycarbonate Material. In: 2016 International Symposium on Technologies in Manufacturing and Mechanical Engineering, 28-30 December 2016, Hong Kong. (In Press)

T

TOLEGO, EFRAIM (2016) Rancang Bangun Alat Simulasi Pembelajaran Desain Produk dan Otomasi dalam Model Automated Guide Vehicle. [Undergraduate thesis]

The, Jaya Suteja (2016) The influence of Depth of Cut, Feed Rate, and Step-over on Surface Roughness of Polycarbonate Material in Subtractive Rapid Prototyping. In: Proceedings of Second International Conference on Electrical Systems, Technology and Information 2015 (ICESTI 2015). Springer , Singapore, pp. 409-414. ISBN 978-981-287-988-2

This list was generated on Wed Feb 21 08:28:16 2018 WIB.