Items where Division is "Department of Manufacturing Engineering" and Year is 2017

Group by: Creators | Item Type | No Grouping
Jump to: C | H | M | S
Number of items: 6.

C

Candra, Susila and Batan, I Made Londen and Pramono, Agus Sigit and Berata, Wajan (2017) Modeling of the minimum variable blank holder force based on forming limit diagram (FLD) in deep drawing process. In: International Conference on Informatics, Technology and Engineering 2017 (InCITE 2017), 24-25 August 2017, Bali, Indonesia.

H

Hariyanto, Yosita Agustina (2017) Pengaruh Variasi Temperatur Pemanasan dan Waktu Penahanan (Holding Time) Terhadap Nilai kekerasan Material Medium Carbon Steel (ST-60) Pada proses Hardening. [Undergraduate thesis]

Hasibuan, Berlin Glory (2017) Identifikasi kegagalan Prosedur pada Proses Melting dengan Metode Metode Failure Mode and Effect Analysis pada Produk Lingkar Roda XYZ- Series di PT. XYZ. [Undergraduate thesis]

M

Moslem, Buyung (2017) Perancangan Mould Produk Tutup Galon Dispenser Anti Tumpah. [Undergraduate thesis]

S

Soesanti, Arum and Fatmawati, Akbarningrum and Simangunsong, Tuani Lidiawati and sulistyowati, wiwik (2017) PENGEMBANGAN PERIKANAN DI DESA PUNGPUNGAN DAN MOJOSARI, KECAMATAN KALITIDU KABUPATEN BOJONEGORO. In: Konferensi Sinergi PKM-CSR, 19-22 Oktober 2017, Universitas Negeri Sebelas Maret, Surakarta.

Suteja, The Jaya and Karim, Azarul and Yarlagadda, Prasad KDV and Yan, Cheng (2017) Estimating life cycle cost for a product family design: The challenges. In: International Conference on Informatics, Technology and Engineering 2017 (InCITE 2017), 24–25 August 2017, Bali, Indonesia.

This list was generated on Wed Jun 19 00:15:37 2024 WIB.